E+G Edge protection seal profile corners

Edge protection seal profile corners from Elesa+Ganter

With edge protection seal profiles corners GN 2181, right-angle sealing paths can be quickly and easily implemented without a minimum laying radius or manual “free-cutting” of the profile. The corner joint is sealed and firmly attached thanks to vulcanization.
The leg length l can be shortened or extended with the corresponding section of GN 2180. Installed “compressed” with an excess dimension of about 1% of the total length, the joints are tightly fitting and do not require adhesive.
During operation, the profile must experience deformation to dimension w₂ in order to ensure an optimal sealing effect.

The profiles made of NBR are intended for uses in contact with oils, fuels or lubricants. The profiles made of NBR are intended for uses in contact with oils, fuels or lubricants.
The EPDM versions are made of UL 50 and UL 94-HB certified edge protector sealing profiles.

Types:
 – Type A: Upper seal profile
– Type D: Side seal profile

Clamping profile / Sealing profile

Ethylene propylene diene rubber EPDM
– Black
– Clamping profile hardness 65 ±5 Shore A
– Sealing profile hardness 25 ±5 Shore A
– Temperature resistant -40 °C to 100 °C

Acrylonitrile butadiene rubber NBR
– Black
– Clamping profile hardness 60 ±5 Shore A
– Sealing profile hardness 25 ±5 Shore A
– Temperature resistant -30 °C to 100 °C

Clamp insert
Steel wire polyester clamping band

Datasheet GN 2181