Edge protection seal GN 2180

Edge protection seal from  Elesa+Ganter

E+G GN 2180 can be used to seal doors, covers and hatches. The profiles are pressed by hand onto the front of metal sheets and plates. The embedded clamp insert prevents detachment. Glue or other adhesives are not required.

When assembled, the profile should deform slightly according to w2 (see datasheet). This ensures an optimal seal. Adherance to the guideline placement radii (r1… r4) in the data sheet is recommended in order to ensure a tight profile seal and to make assembly easier.

The NBR profiles are recommended for use in cases where contact with fuels, oils or coolants can occur.

EPDM profiles are certified according to UL 50 and UL 94-HB and are therefore approved for the US-American and the Canadian market.

Types:
– Type A: Upper seal profile
– Type D: Side seal profile

Clamping profile / sealing profile, two materials:

EPDM ethylene propylene diene rubber in black colour.
Clamping profile hardness 65 +/-5 Shore A
Sealing profile hardness 25 +/-5 Shore A
Temperature resistant -40 to 100 °C

NBR acrylonitrile butadiene rubber.
Clamping profile hardness 60 +/-5 Shore A
Sealing profile hardness 25 +/-5 Shore A
Temperature resistant -30 to 100 °C

Clamp insert made from steel wire polyester clamping band.

Datasheet GN 2180