E+G U-handles with signal

Elesa+Ganter EBR-SWB Handle with bistable electronic switch. This handle is used when it is necessary for the switching to be prolonged over time. Through external logic, the Leds can be configured to indicate the specific status of the button. Example: button in neutral position green Led on, button switched on red Led off. The mechanical life of the button is 200000 cycles. In case of use of an extension with angled connector, the direction of the cable output is shown in the Fig.1. EBR-SWB handle can be assembled with EBR neutral handle. The device is made up of a bistable normally open contact (NO). Switching takes place by pressing the purple button, and remains switched until pressed again. For more information please see the original Elesa+Ganter data sheet.

Elesa+Ganter GN 331 Tubular handles with power switching function with aluminum tube in black or natural colour. Without button, with one or two buttons. Wth or without emergency stop. E+G GN 330 wire is compatible with this handle.

Elesa+Ganter GN 332 Tubular handles with power switching function handles with power switching function with aluminum tube in black or natural colour. Without button, with one or two buttons. Wth or without emergency stop. 

Elesa+Ganter EBR-PN technopolymer handle with pneumatic drive supplied with quick couplings for direct fitting of a tube Ø 4 mm for pneumatics.
The handle is available in the following standard executions:
- EBR-PN-3/2-NO: the pneumatic valve is normally open. The actuation of the button closes the air passage.
- EBR-PN-3/2-NC: the pneumatic valve is normally closed. The actuation of the button opens the air passage.
- EBR-PN-5/2: the actuation of the button switches the output channel of the air, between the two available.

E+G M.2000-SWM bridge handle in self-extinguishing technopolymer with monostable electrical switch. These handles are typically assembled on machine doors or protections. With the appropriate electrical connection, it is possible to configure the colour of the LED strip to indicate the status of the guard. For more information please see the original Elesa+Ganter data sheet.